PS imitation wood (non-wpc wood plastic) sheet floor use and construction instructions

Home > News > Construction Technology > PS imitation wood (non-wpc wood plastic) sheet floor use and construction instructions

Construction Technology

2018-08-01 12:02:02

	1. Tools: general woodworking tools, electric drills, drill tails, chamfering knives, sawing machines, cutting machines.

	2. Cutting processing: The speed of the woodworking cutter is about 3600 rpm. The tungsten steel saw blade is required to be 10 inches to 12 inches in diameter, and the serrations are 36-42 teeth. The fewer the number of saw blades, the easier it is to cut and chip. When cutting, spray anti-rust oil (WD-40) on the saw blade to avoid debris sticking.

	3. Trimming repair: Cut the cut surface with fine sandpaper, or scrape the blade and cut the scissors.

	4. Base beam: galvanized square tube (100 X 50 - 2.3mm thick) and galvanized square tube (1 1/2 inch - 2mm thick).

	4-1. Floorboard 2.5 cm or more: 40 cm is recommended for beam spacing.

	4-2. 2 cm of floor board: 30 to 35 cm is recommended for beam spacing.

	5. Fastening of the fastener floor: It needs to be fixed with screws. It can't be fixed with nail gun or nail.

	The self-tapping screws for the steel structure base and the wood screws for the base of the plate; the screw size is 8 (the diameter is about 4.2mm), the length of the screw needs to be 2-3 cm longer than the fastener; two fasteners are needed for the joint of the plate. Fixed, no gaps are left in summer construction, and 2-3mm gap is left in winter construction.

	6. Maintenance and cleaning: Wash with water or wipe with wooden floor cleaner.

	7. Illustration of the construction method of fastener floor:

	Wood screws, self-tapping screws, saw blades, electric drills

[Return Home] [Print] [Go Back]

News